Wednesday, December 24, 2014

We have classic tie knots,like the simple,four-in-hand,prince albert,the kelvin,half-windsor,the pratt,the windsor,and the bow-tie;But today we will be looking at windsor knot.

 This might not be new to many of us,but it wont be a bad idea to go over it again;This particular way of knotting a tie is called the WINDSOR KNOT,and neck-ties knotted in this way are strictly worn for job interviews,presentation,courtroom appearances,contract appointments.

  The following are steps taken to knot a tie using the windsor knot style:
* Start with the wide end of your neck tie on the right,extending about 12 inches below the narrow end on the left.

* Then cross the wide end over the narrow end.

* Bring the wide end up through the loop between the collar and your tie.

* Then bring the wides back down.

* Pull the wide end underneath the narrow end and to the right,back through the loop and to the right again so that the wide end is inside out.

* Bring the wide end across the front from the right to left.

* Then pull the wide end up through the loop again.

* Bring the wide end down through the knot in front.

* And using both hands tighten the knot carefully and draw it up to the collar.
With these following steps,am too sure you will always look outstanding on your different ocassions that permit the use of windsor knot.
N.B: Windsor knot is worn on spread collar shirts.
Source credit:

You Might Also Like